Lithofin MN Power-Clean

Concentrate: basic cleaner for all natural stones.

Article number : 160
For thorough cleaning in case of severe general and greasy dirt, residues of floor care products, etc. For regular cleaning of high-traffic and outdoor areas such as shopping centres and food courts. For final cleaning of new surfaces at building sites.
Product type: alkaline cleaner
  • concentrate - high yield
  • highly effective
  • low on odour
Coverage approx. 10 to 30m²L
Stocking closed, cool, up to 3 years
Packaging 1 L, 5 L
  • pdf
    Technical Information - Lithofin MN Power-Clean (EN)
  • pdf
    Material Safety Data Sheet - Lithofin MN Power-Clean (EN)
    311 KB
  • pdf
    Ingredients according to Reg (EC) No. 648/2004 (EU)
    Lithofin MN Power-Clean

First remove any dirt and care product residues with Lithofin MN Power-Clean. Afterwards wipe the surface with Lithofin MN Care-Sheen. (in case of hard wear: apply Lithofin MN Care-Seal diluted 1:4 with water). You may have to repeat this procedure in order to achieve a rich sheen. Use Lithofin MN Wash & Clean or Lithofin EASY-CARE for regular maintenance.

First carry out a basic cleaning with Lithofin MN Power-Clean. Regularly wipe the surface with a moist cloth in order to achieve a well maintained surface appearance. Always add one squirt of Lithofin MN Wash & Clean to the bucket of cleaning water to protect and maintain at once.  After every fourth cleaning, touch the surface up with Lithofin MN Care-Sheen. Lithofin MN Care-Sheen protects and maintains sheen on all polished surfaces.

The limescale has penetrated deeply into the stone and has damaged the polish of the surface. Removing these deposits without further damaging the surface is impossible. The surface can, however, be touched up, so the unsightly stains no longer show as prominently. Mechanically remove the surface deposit with a white pad and Lithofin MN Power-Clean. A shadow or a dull spot will remain visible. Protect the surface with Lithofin MN Stain-Stop and regularly apply Lithofin MN Polish Cream.

Brush the surface several times with hot water and a dash of Lithofin MN-Power-Clean. Occasionally you may have to put a wet cloth on the area and allow the product to work for some time.

Different browser language detected

We have detected that your browser supports a different language than the one currently being displayed. Our website is also available in your language. Would you like to switch to your language?

Switch to language